由于現在農村建設發展快，人們對混凝土攪拌機的需求不斷增加，當然為了更好更安全的使用設備，就需要您對該設備的各個系統有所了解，下面小編就來為您分析一番。

Due to the rapid development of rural construction, people's demand for concrete mixers is increasing. Of course, in order to use the equipment better and more safely, you need to know about the various systems of the equipment. The following sections will analyze for you.

混凝土攪拌機的供水系統，一般由水泵，水泵驅動裝置，水箱和量水器等組成，與一般攪拌機供水系統相仿。

The water supply system of concrete mixer is generally composed of water pump, water pump drive device, water tank and water gauge, which is similar to the water supply system of general mixer.

在這個供水系統中只設置一個能承受一定空氣壓力的蜜蜂水箱量水器和有關控制水閥。工作時，利用汽車的壓縮空氣經減壓通入水箱，而將水箱儲水從管道壓出供清洗或攪拌混凝土使用。

In this water supply system, only one honeybee tank water gauge and relevant control water valve capable of withstanding a certain air pressure are set. When working, the compressed air of the vehicle is used to enter the water tank through decompression, and the water stored in the water tank is pressed out of the pipe for cleaning or mixing concrete.

供水系統的原理，是由密封壓力水箱、閘閥、水表(量水器)和三通閥等組成。壓力水箱下部接出水管，并通過閥門分別與水源或工作部分相通。

The principle of water supply system is composed of sealed pressure water tank, gate valve, water meter (water meter) and three-way valve. The outlet pipe is connected to the lower part of the pressure water tank and connected to the water source or working part through the valve.

水箱蓋上裝有排氣閥和安全閥，以備進水排氣和超壓保護時起作用。另外還接有壓縮空氣進氣管，壓縮空氣引自汽車的儲氣罐，經減壓閥和控制閥供水箱排水。

The cover of the water tank is equipped with an exhaust valve and a safety valve for water inlet and exhaust and overpressure protection. In addition, it is also connected with a compressed air intake pipe. The compressed air is introduced from the air storage tank of the car, and is supplied to the water tank for drainage through the pressure reducing valve and control valve.

工作前先向水箱加滿用水，工作時與水箱接通壓縮空氣，按需要調整三通閥，水既沿管路和閥門被送到?jīng)_洗管或攪拌筒中。

Fill the water tank with water before work, connect compressed air with the water tank during work, adjust the three-way valve as required, and the water is sent to the flushing pipe or mixing cylinder along the pipeline and valve.

氣壓供水系統加水量一般在水箱的四分之三處為宜；車輛在行駛時水路系統中各個閥門均應處于關閉狀態，以免影響車輛的制動性能，或燒結摩擦片，從而影響車輛的制動性能。

The water volume of the pneumatic water supply system is generally three quarters of the water tank; All valves in the waterway system shall be closed when the vehicle is running, so as not to affect the braking performance of the vehicle, or sinter friction plates, thereby affecting the braking performance of the vehicle.

禁止隨意焊接和改動水箱，避免重物撞擊；經常檢查閥體是否堵塞或是否有工作異常；在有結冰可能的環境中使用時，供水系統須排空存水，防止管路凍裂；經常檢查系統的密封性，拆卸修理后，關鍵部位要涂螺紋密封膠。

It is prohibited to weld and change the water tank at will to avoid heavy object impact; Check the valve body frequently for blockage or abnormal operation; When the water supply system is used in an environment with the possibility of icing, the water storage must be drained to prevent the pipeline from freezing; Check the tightness of the system frequently. After disassembly and repair, apply thread sealant to key parts.

混凝土攪拌機的供水系統怎么好使用？這個問題的相關內容就在以上講解完畢了，您有什么疑惑或者需求就來我們網站http://www.jiyini.cn咨詢吧！

How to use the water supply system of concrete mixer? The relevant content of this question has been explained above. If you have any doubts or needs, please come to our website http://www.jiyini.cn Consult!